Skystars F722 HD Pro2
Производитель
Skystars
Категория
FC single
Процессор
STM32F722
Гироскоп
BMI270
Монт. размер
30,5x30,5мм
Напряжение
до 6s
| MCU: STM32F722RGT6 216MHz |
| Gyroscope: BMI270 |
| Baro:Bmp280 |
| OSD: Betaflight SPI OSD DJI HD OSD(UART6) |
| Black box: 16MB |
| 6x Uarts: UART 1/2/3/4/5/6 |
| 4x PWM outputs |
| 1x I2C |
| 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red) |
| USB Type-C(USB2.0) |
| 1x JST-SH1.0_8pin connector (Gnd/Vbat/S1/S2/S3/S4/Rx3/Curr) |
| 1x JST-SH1.0_6pin connector (R1/G/R6/T6/G/10V) |
| VTX 10V/Vbat filtered power ON/OFF switch |
| DJI FPV OSD is supported by any spare UART |
| LED: |
| 4 LED independent pads, support WS2812 programming lamp output. |
| Receiver: Support Sbus, crsf, ibus, SBUS, XBUS, support 3.3v Spektrum satellite receiver, The default receiver input is UART1(You can solder ELRS RX on UART1), F7 has a built-in inverter, which can actually be installed in any spare UART. |
| Power: |
| Input voltage: 3-6S |
| BEC: 5V/10V 3A max dual-channel BEC supports stable power supply on the sky side of DJI |
| LDO 3.3V: Max.250mA |
| FC Firmware: |
| BetaFlight firmware: SKYSTARSF722Pro |
| INAV firmware:SKYSTARSF722HD |
| Installation size: 30.5mm × 30.5mm The installation hole is M4 and supports shock column installation |
| External size 39mm × 39mm |
| Flight control weight: 6.9g |
| Flight control onboard voltage sensor |
Всего комментариев: 0