GepRC SPAN F405 HD 50A Stack

GEP-F405-HD is a plug-and-play flight controller with F405 chip and a tower flight system with BLheli_32 50A 4 and 1 32-bit electrical modulation. It integrates 16Mb black box, MPU6000 gyroscope and barometer for a more delicate hand experience.

GEP-F405-HD supports direct insertion into DJI Digital FPV System, which can avoid the trouble of welding.Upgrade the USB interface of Type-C, greatly improve the life of the socket and reduce the risk of bad contact.

GEP-F405-HD can be used together with GEP-G50A-4IN1 for perfect flight effect.

GEP-F405-HD supports all kinds of receivers, including Sbus,PPM,CRSF,DSMX,iBus, DUMD and so on. You don’t have to worry about the remote control in your hand can’t be used.

  • MCU: STM32F405
  • IMU: MPU6000(SPI)
  • DJI FPV Air Unit Supported.
  • BlackBox: 16Mb onboard Flash
  • Type-C USB interface
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Baro:BMP280
  • BEC Output: 5V,9V BEC
  • Integrated LC Filter
  • Firmware target:GEPRCF405
  • Size: 36x36mm board, φ4mm with Grommets φ3mm
  • Power input: 3-6S LiPo
  • 6x UART

BL32 50A ESC 4IN1:

  • MCU: STM32F051K86(32bit 48mHz)
  • Continuous Current: 50A
  • Peak Current: 55A (5S)
  • Current sensor: YES
  • Telemetry:Supported
  • Support DSHOT1200/DSHOT600, PWM, Multishot, OneShot
  • Firmware Version:GEPRC-BL32-4IN1
  • Input Voltage: 3-6S Lipo

  • 1x GEP-F405-HD Flight Controller
  • 1x GEPRC G50A ESC
  • 1x 35V 470uf  Capacitor
  • 4x Silicon grommets M4 to M3
  • 4x M3*22mm Screw
  • 4x M3*30mm Screw
  • 1x XT60 Power Cable
  • 1x ESC Cable
  • 1x DJI Cable
Всего комментариев: 0

Оставить комментарий